Zebra printer feeds too far. See the Zebra label software.

The stored length is longer than the stock, or it never saw a gap. Set size, calibrate, print one.

Zebra printer feeds too far between labels

Published: · 3 min read · Problem

A Zebra printer feeds too far between labels when the length it's printing is longer than the stock, or when it never saw a gap. Set the length to the real label, calibrate, and print one test.

How it works

Set the real length so it stops on the gap

When a Zebra runs past the label, the length is wrong or the gap wasn't found. Set the length and calibrate.

Set the real length

Match the size to your roll and print one test before the rest. No signup.

Open the free label maker

1Why

Why a Zebra feeds too far

You print one label and the printer keeps going. A blank label follows, or a long strip of paper.

There are two usual reasons. The first is length: if the job is longer than the label on the roll, the printer keeps feeding until the job is done. The second is the gap: if the printer never finds the space between labels, it doesn't know where to stop.

Good to know: continuous (no-gap) stock with gap sensing on will hunt and feed a lot of paper. Match the sensor mode to the media.

2Examples

Labels to try it with

These are real renders from the editor, with made-up details. Click one and it opens with that exact label.

3How to

How to fix a Zebra that feeds too far

When the test stops where it should, print the run from the same design. Save a JSON copy so you can open it again later. Printing a list? The same design works for barcode labels from Excel.

  1. Open https://app.mylabelmaker.com. No signup.
  2. Set the label size to the exact width and length of the roll in the printer.
  3. Calibrate the gap or black-mark sensor if you just changed stock.
  4. Print one test label. Don't send a whole stack until it stops on the next gap.

4Good to know

A wasted 4x6 label after every job

If you lose a blank 4x6 after every job, the length is wrong.

Fix it once. Don't keep reprinting to "use up" the extra, because the next job will do the same thing.

Set the length to the label you actually have, and the printer stops where it should.

Keep the Zebra labels page open while you sort out the job, and check the width before you reprint. If the job came to you as code, the ZPL viewer lets you check the size before you print.

Questions about a Zebra printer feeding too far

Why does my Zebra printer feed too far between labels?

The stored length is longer than the stock, or the printer never saw a gap. Set the label to the real roll size, calibrate, then send one test from the free label maker.

Why does my Zebra waste a blank 4x6 after every job?

The label length is wrong. Set the exact length of your roll once, instead of reprinting to use up the extra.

Why does my Zebra feed a lot of paper on continuous stock?

Continuous stock has no gap, so with gap sensing on the printer hunts for one and keeps feeding. Match the sensor mode to the media.